Meridian America Link/Customer Controlled Routing User Manual
Page 486
468 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 8: Load the application software from tape (continued)
Figure 244
Module name prompt
ADD MODULE NAME AND ADDRESS TO TCPIP TRANSPORT PROVIDER DATABASE
If you are not sure how to answer any prompt, type "?" for HELP.
Enter the MODULE NAME to be added to the tcpip transport
provider database [?, or module name]:
22
You are prompted for the name of the Application Module or
IPE Module (Figure 244). (The term Òmodule nameÓ refers to an
Ethernet host computer, which in this case is the IPE Module or
Application Module.) Type the module name and press [Return]. The
module name must not exceed eight alphanumeric characters. For
more information about module names, consult your network
administrator.
Figure 245
Module address prompt
Enter the MODULE ADDRESS to be added to the tcpip transport
provider database [?, or module address]:
23
You are prompted for the address of the IPE Module or Application
Module (Figure 245). Type the module address and press [Return].
The module address must be four numbers separated by periods,
such as Т12.234.67.89.У For more information about module
addresses, consult your network administrator.
Figure 246
Reenter prompt
If you made any mistakes in entering the module name and IP address,
you can correct them. Would you like to re-enter the module name or
IP address? [y, n]