Meridian America Link/Customer Controlled Routing - Manual (Page 335)

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 317
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Configure SDI port for conshare (X11 Release 18 or later)
The SDI port is used for the optional console sharing feature, which allows
the IPE Module or the Application Module console to access Meridian 1
administration and maintenance programs. Port settings on the card should
reflect TTY mode at 2400 baud. Define the SDI port and its characteristics
by responding to the following prompts in LD 17.
Table 112
LD 17ÑConfigure SDI port (X11 Release 18 or later)
Prompt Response Comment
REQ CHG Create or change information in the database
TYPE CFN Configuration record data block
ADAN NEW TTY x Add SDI on port x (0Ð15) for console sharing
CTYP SDI
SDI2
SDI4
XSDI Single port SDI card
Dual port SDI card
Four port SDI card
SDI Paddle Board
DNUM 0Ð15 Device number (same as ADAN number)
USER aaa aaa
CDR
BUG
CSC
CTY
MTC
NOO
SCH
TRF
Enter one or more of the following terminal
functions:
CDR data link
BUG error messages on this port
Automatic Set Relocation and Attendant
Administration messages
CDR TTY port
Allow maintenance overlays
No overlay allowed
Allow service change overlays
Traffic reports
XSM YES, (NO) SDI port for the System Monitor
ADAN Go to next prompt