Meridian America Link/Customer Controlled Routing User Manual

Page 447

Chapter 14: Software installation, upgrade, and update procedures 429

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide

Procedure 6: Load the operating system tape on an IPE
Module or an Application Module with an MVME167 card

If you have just installed a new MVME167 card in an Application Module
and you are installing the software for the first time, you need to do steps
2Ð6. Otherwise, skip these five steps.

Note: If you intend to activate CCR and use terminals or printers,
ensure that the MVME332XT or MVME332XTS card is installed
before you start this procedure.

This procedure assumes that you have backed up all files and have powered
down the IPE Module or the Application Module (Procedure 4).

Turn on the power. If the Ò167-Diag>Ó or the Ò167-Bug>Ó prompt
appears, go to step 5. If the Ò4120-Diag>Ó or the Ò4120-Bug>Ó prompt
appears, go to step 4. If the following messages appear on the
console, go to step 2.

Figure 172
System restart messages (IPE Module or MVME167 card)

VME167 Debugger/Diagnostics Release Version 1.4 - 07/22/92
COLD Start

Local Memory Found = 00800000 (&8388608)
MPU Clock Speed = 25Mhz

Type h as soon as messages start to appear. If you are too late,
press either the [F5] or the [Break] key.

The start-up interrupt menu appears.

If you are using an IPE Module, go to step 4.

If you are using a new MVME167 card, go to step 5.

If you are using a previously configured MVME167 card, go to
step 7.