Meridian America Link/Customer Controlled Routing - Manual (Page 188)

170 Chapter 9: Meridian Link/CCR interface cabling
553-3202-210 Standard October 1998
Figure 43
IPE Module Option 11 connections (Part 1)
Note 1:
Note 2:
Note 3:
Note 4:
It is recommended that the TDS/DTR card be
installed in position 1. The SDI/DCH card may be
installed in any other position except position 0
(for the CPU/Conf card).
Refer to the Meridian 1 Option 11 Installation
Guide (NTP 553-3011-210) for cross connections.
The NTAK03 TDS/DTR card is not available for Option
11E.
Use an NT1R03D extension cable if you need
additional length.
A0368901
Meridian 1 Option 11
NTAK19AA
(2-port
cable)
port 0
port 1
J1 (Note 1)
Internal
bus
NTAK01
CPU/Conf
port 0
SDI
Internal
bus
Method 1
Method 2
NTAK03
TDS/DTR
(Note 3)
Connector
Panel
NT1R03CA
(extension
cable)
NT1R03AA
(octopus
cable)
1
3
5
7
IPE
Module
Connector
Panel
NT1R03CA
(extension
cable)
1
3
5
7
Note 4
Note 4
IPE
Module
NT1R03AA
(octopus
cable)