Meridian America Link/Customer Controlled Routing User Manual
Page 482
464 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 8: Load the application software from tape (continued)
16
If you are activating the Meridian Link application, you are prompted
to enter the Meridian Link protocol.
If you are using the X.25 protocol, type x, press [Return], then go to
step 19.
If you are using the TCP/IP protocol, press [Return], then go to
step 17.
Figure 238
IP address prompt
Meridian Link using a TCP/IP connection.
If you would like a default gateway IP address configured or changed, please
enter the IP address in internet dot notation (e.g. 47.82.45.10). For no change
enter
17
To configure or change a default gateway IP address, type the IP
address in the decimal format and press [Return]. If no modification
or configuration is required, simply press [Return].
Figure 239
Subnet mask prompt
Saving default gateway IP address:
If you would like a default subnet mask configured or changed,
please enter the subnet mask (e.g. 255.255.0.0). For no change enter
18
To configure or change a default subnet mask, type the subnet mask
address in decimal format and press [Return]. If no modification or
configuration is required, simply press [Return].