Meridian America Link/Customer Controlled Routing - Manual (Page 16)

xvi About this guide
553-3202-210 Standard October 1998
Chapter 3: Overview of Customer Controlled Routing This chapter
provides an overview of CCR, describes its concepts, and lists required
hardware and software.
Chapter 4: Meridian Link/CCR hardware This chapter provides an
overview of hardware components.
Chapter 5: Hardware installation overview This chapter lists the tools and
provides tables to describe the installation of an IPE Module or an
Application Module.
Note: If you intend to install an IPE Module or an Application
Module, refer to Table 11 (IPE Module) or Table 12 (Application
Module) in this chapter.
Chapter 6: Site survey/installation checklist This chapter provides a
checklist to ensure that all hardware and software requirements are met for a
successful installation.
Chapter 7: Unpack and inspect hardware This chapter provides
information on receiving, unpacking, and inspecting the IPE Module and
Application Module hardware components.
Chapter 8: Hardware installation procedures This chapter contains all of
the main hardware installation procedures, with references to surrounding
chapters for further information.
Chapter 9: Meridian Link/CCR interface cabling This chapter describes
the cabling requirements. Two following chapters describe how to set up
terminals, and how to configure the Meridian 1 system.
Chapter 10: Installing peripheral devices This chapter describes the
procedures for how to set up and configure video display terminals and
printers supported by the Meridian Link and CCR appplications.
Chapter 11: Peripheral device cabling interface This chapter provides
information on installing and configuring modems and the A/B switchbox.
Chapter 12: Meridian 1 configuration for Meridian Link/CCR This
chapter shows how to use various software programs to configure the
Meridian 1 to support Meridian Link and CCR.