Meridian America Link/Customer Controlled Routing User Manual

Page 437

Chapter 14: Software installation, upgrade, and update procedures 419

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide

Procedure 5: Load the operating system tape on an Application Module
with an MVME147 card (continued)

When the tape indicator goes off, type 2 and press [Return].

You are prompted to enter the alternate boot device. Type 4, and
press [Return].

When the start-up interrupt menu reappears, type 1 and press
[Return] to continue the system start-up.

The system starts up. A series of test messages will appear on one
line across the screen for approximately ten minutes. The system
start-up messages begin to appear as shown in the following figure.

Figure 154
System start-up messages

Testing Complete
Autoboot in progress ... To abort hit

RAM address from VMEbus = $00000000

Booting from: VME147, Controller 4, Device 0
Loading: Operating System

Volume: V/68

IPL loaded at: $001F0000
MVMETAPE IPL Version 1.0

***********************************************************************

System V/68 Release R3V7 M68030 Version 920526

Real mem = 6291456
Avail mem = 4964352
Buffers = 60

INIT: SINGLE USER MODE
***
erase = # kill = @ intr = DEL quit = ^|
***
147 SCSI configuration
Device Addr Vers Revision Seria Blocks Size Vendor Description
------- ---- ---- -------- ------- ------- ---- ------------------------
Disk 00 0001 M606... ....... 0352175 0512 FUJITSU M2614S
Tape 40 0001 RV F... ....... 0000000 0000 TEAC MT-2ST/N50
Enter the correct date and time EST using one of the following formats
[mmddhhmmyy] or [mmddhhmmyyyy]:

Type the date in the form MMDDHHMMYY (month, date, hour in
24-hour clock format, minute, yearÑnote that the time should be in
Eastern Standard Time), or MMDDHHMMYYYY, and press [Return].

Example: 0314163098 or 031416301998