Meridian America Link/Customer Controlled Routing - Manual (Page 279)

261
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 10: Installing peripheral devices
You should use this chapter in conjunction with Chapter 5, ÒHardware
installation overview,Ó which links hardware installation procedures in
easily understood tables (Tables 11 and 12).
The following procedures describe how to set up the video display terminals
supported by the Meridian Link and CCR applications. If the terminal you
are configuring is different from these (but 100 percent compatible with the
recommended terminal), use the most similar settings available and follow
the instructions in the manual that came with the terminal.
This chapter also contains procedures for configuring personal computers
running Reflection 4+ communication software and setting the switches on
printers supported by Nortel.
VT220, VT320, and VT420 terminals
Table 95 contains the setup values for the VT220 terminal. Table 96
contains the setup values for the VT320 terminal. Table 97 contains the
setup values for VT420 terminals.
!
CAUTION
Risk of potential data loss
Setup mode can be entered at any time, but it is
recommended that you do not do so while information is
being printed on the screen.