Meridian America Link/Customer Controlled Routing - Manual (Page 511)

Chapter 15: Link configuration 493
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 14: Changing Meridian Link (link 1) parameters (continued)
Table 142
X.25 and LAPB parametersÑLink 1 (continued)
Link parameter Allowed values
(defaults in parentheses)
Description
Incoming window size 1Р(2)Р7 Maximum number of outstanding
incoming packets without an
acknowledgment
Outgoing window size 1Р(2)Р7 Maximum number of outstanding
outgoing packets without an
acknowledgment
Throughput
negotiation used (0)Ð1 Specify whether throughput negotia-
tion may be used: 0 = no; 1 = yes
Incoming throughput
class 3Р(10)Р12 Maximum amount of incoming
information on a connection basis,
meaningful only if Throughput
Negotiation Used is set to yes.
Outgoing throughput
class 3Р(10)Р12 Maximum amount of outgoing
information on a connection basis,
meaningful only if Throughput
Negotiation Used is set to yes.
Lowest LCN for
DTE/DCE* (-1) Specifies the lowest X.25 virtual circuit
number that will be assigned for an
incoming (if DTE) or outgoing (if DCE)
X.25 call request. Not used by the AM.
Default value is Ð1.
Highest LCN for
DTE/DCE* (-1) Specifies the highest X.25 virtual circuit
number that will be assigned for an
incoming (if DTE) or outgoing (if DCE)
X.25 call request. Not used by the AM.
Default value is Ð1.
Note: Parameters marked with an asterisk (*) cannot be changed.
Ñ continued С