Meridian America Link/Customer Controlled Routing - Manual (Page 389)

371
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 14: Software installation,
upgrade, and update procedures
This chapter describes how to
¥ initially configure a new IPE Module or the Application Module
Note: If a redundant Meridian Link is required, a second module must
be installed and configured separately.
¥ properly power down
¥ upgrade from one release to another
¥ update from one issue of a release to another issue of the same release
ATTENTION
Before proceeding with any software installation, upgrade, or update,
ensure that all discrepancies found in Chapter 6, ÒSite survey/
installation checklistÓ have been corrected.
The operating system and application software on the IPE Module or the
Application Module are installed at the factory. When the module is
installed at your site
¥ enter a keycode to activate the correct application or applications
¥ configure the new module
¥ change some link parameters, if necessary