Meridian America Link/Customer Controlled Routing - Manual (Page 491)

Chapter 14: Software installation, upgrade, and update procedures 473
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 9: Restore configuration files and data files from the backup
tape (continued)
Figure 254
Rstdata messages screen 2
Files will be restored to:
/usr/maint/files/AMprofile
/usr/maint/files/AutoStart
/usr/maint/files/IncrDY
/usr/maint/files/IncrTM
/usr/maint/files/Port
/usr/maint/files/Prefs
/usr/maint/files/Speed
/usr/maint/conf/hdlchlnk.dataf
/usr/maint/conf/hdlcmlnk.dataf
/usr/maint/conf/lh.config
/usr/mlusr/conf/loop13DCE.d
/usr/mlusr/conf/loop13DTE.d
/usr/mlusr/conf/loop31DCE.d
/usr/mlusr/conf/loop31DTE.d
/usr/mlusr/conf/tscfg.datafile
/usr/mlusr/conf/vlink.datafile
/usr/mlusr/conf/x25bcf333.2
/usr/mlusr/conf/x25hlink.datafi
(Actual list of directories may differ depending on the application)
Please enter ÔyÕ to do restore, or ÔnÕ to quit: [y,n]
8 You are prompted to restore the files. Type y and press [Return].
Various prompts appear, followed by the message ÒRestore
successfulÓ when the procedure is completed (Figure 255).
Note: The following figure is illustrative only. It shows restoration
messages for Meridian Link. If you are restoring for CCR, your
messages will be different.