Meridian America Link/Customer Controlled Routing - Manual (Page 498)

480 Chapter 15: Link configuration
553-3202-210 Standard October 1998
Link 1ÑX.25 protocol (Meridian Link)
Link 1 is defined as the host link using the X.25 protocol if services 97, 98,
100, or 101 are equipped with the following characteristics (which are
described in more detail later in this chapter):
Protocol: X25 Link type: 2
Machine ID: x25dest
Delay: 0
Port type: X
Physical DTE(0)/DCE(1): 1
PDN type: 44 Maximum Frame length: 135
Baud rate: 19200 Fail timer: 150
RFS timer: 150 Internal address: 1
Remote address: 3 T1: 30
Maximum out frames (K): 7 Maximum trans attempts (N2): 7
Local DTE address: 000000990100
Flow control negotiation: 0
Incoming packet size: 128
Outgoing packet size: 128 Incoming window size: 2
Outgoing window size: 2 Throughput negotiation used: 0
Incoming throughput class: 10 Outgoing throughput class: 10
Lowest LCN for DTE/DCE: Ð1 Highest LCN for DTE/DCE: Ð1
Lowest LCN: 1 Highest LCN: 4095
LOC LIC: Ð1 HOC HIC: Ð1
T10: 1800
T11: 2000
T12: 1800
T13: 1800 T14: 600
T15: 1500 T16: 1300
Maximum T12 retries: 3 Maximum T13 retries: 3
If your Meridian Link application requirements are satisfied by the default
configuration, no more procedures are required. You may choose to verify
the status of the link using Procedure 12: Verifying the link status, in this
chapter.