Meridian America Link/Customer Controlled Routing - Manual (Page 512)

494 Chapter 15: Link configuration
553-3202-210 Standard October 1998
Procedure 14: Changing Meridian Link (link 1) parameters (continued)
Table 142
X.25 and LAPB parametersÑLink 1 (continued)
Link parameter Allowed values
(defaults in parentheses)
Description
Lowest LCN* (1) Specifies the lowest X.25 virtual
circuit number that will be assigned
for an incoming or outgoing X.25 call
request. Default value is 1.
Highest LCN* (4095) Specifies the highest X.25 virtual
circuit number that will be assigned
for an incoming or outgoing X.25 call
request. Default value is 4095.
LOC LIC* (-1) Specifies the lowest X.25 virtual
circuit number that will be assigned
for an incoming (if DCE) or outgoing
(if DTE) X.25 call request. Not used
by the AM. Default value is Ð1.
HOC HIC* (-1) Specifies the highest X.25 virtual
circuit number that will be assigned
for an incoming (if DCE) or outgoing
(if DTE) X.25 call request. Not used
by the AM. Default value is Ð1.
T10 0Р(1800)Р9999 Amount of time (in 1/10 second
increments) the AM will wait for an
X.25 restart confirmation packet
after sending an X.25 restart packet
to the host.
T11 0Р(2000)Р9999 Amount of time (in 1/10 second
increments) the host will wait for an
X.25 call accept packet after
sending an X.25 call request packet
to the AM.
Note: Parameters marked with an asterisk (*) cannot be changed.
Ñ continued С