Meridian America Link/Customer Controlled Routing - Manual (Page 337)

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 319
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Configuring DNIS to use auto-terminating trunks
Dialed Number Identification Service (DNIS) is an optional feature that
provides the last digits of the dialed number. DNIS is defined by responding
to specific prompts in LD 15, LD 16, and LD 14. This section describes
how you can configure DNIS to use auto-terminating trunks. You can
alternatively configure DNIS to use Incoming Digit Conversion (IDC); refer
to ÒConfiguring DNIS to use Incoming Digit ConversionÓ later in this
chapter.
Note: Meridian Link 5C and CCR Release 3C support up to 31 DNIS
digits. X11 Release 24 is required for this feature. Prior to X11 Release
24, only seven digits were supported.
LD 15ÑCustomer data block
The DNIS option must be enabled in LD 15.
Table 114
LD 15ÑEnable DNIS
Prompt Response Comment
REQ CHG Create or change data in the database
TYPE AML_DATA Change Application Module Link options
CUST 0Ð99 Customer number
OPT DNI DNIS for this customer
¥
¥
¥ Press [Return] until the REQ prompt
appears
REQ CHG, END Either change more customer data or exit
the overlay