Meridian America Link/Customer Controlled Routing - Manual (Page 515)

Chapter 15: Link configuration 497
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 15: Changing Meridian Mail Link (link 2)
parameters (Meridian Link only)
Meridian Link is shipped with a default configuration for the Meridian Mail
Link. If the default configuration is not appropriate, you can use this
procedure to change it. Note that you cannot change the values for the
protocol and link type parameters. For more information, refer to Table 144
at the end of this procedure.
!
CAUTION
Risk of potential data loss
Do not use the change link command without the
direction of Nortel support personnel or host computer
support personnel.
1 Log in as mlusr (if you are not already logged in). The default
password is mlusr.
2 At the Òmlusr>Ó prompt, type display link 2 and press [Return] to see
the current configuration for the link to the host computer.
The default link configuration is displayed, as shown in Table 144.
3 Type change link 2 and press [Return] to begin making changes to
the link.
The first parameter appears, along with possible and current values.
4 Either type a new value for the parameter and press [Return] or just
press [Return] to leave the current value unchanged.
Refer to Table 144 for information on link parameters for the MML.
5 Continue changing parameters until the ÒConfirm (yes or no)Ó prompt
appears.
6 To confirm the changes, type yes and press [Return].
If you made a mistake and wish to redo your changes, type no,
press [Return], and restart this procedure from step 3.
At this point, the changes you have made are temporary.
They are saved in memory, but not on disk (which means that if
the system is restarted, the changes are lost).