Meridian America Link/Customer Controlled Routing - Manual (Page 505)

Chapter 15: Link configuration 487
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 13: Changing AML (link 0) parameters (continued)
Table 141
AML (link 0) parameters (continued)
Link parameter Allowed values
(defaults in parentheses)
Description
Maximum Frame Length (135)
Baud rate 300 600 1200 2400 4800
9600 (19200) 38400 48000
56000 64000 Must be identical to that specified
on the Meridian 1 or host
computer configuration; if
modems are used, must also
match baud rate of the modem
Fail timer 0Р(50)Р9999 Timer value (in 1/10 second
increments) for monitoring the
signals that indicate link failure
RFS timer 0Р(150)Р9999 Timer value (in 1/10 second
increments) for monitoring CTS
or DTR signals after line opening
Internal address (1), 3 1 for DCE; 3 for DTE
Remote address 1, (3) 3 for DCE; 1 for DTE. (This value
must be different from the value
of the internal address. The
combination of values for internal
address and remote address
must be the opposite of the
values for the host. That is, if the
values for the host are 3, 1, the
values for the link must be 1, 3.)
T1 0Р(20)Р9999 Frame recovery time (in 1/10
second increments); must be
identical to the time specified on
the host computer configuration
Ñ continued С