Meridian America Link/Customer Controlled Routing - Manual (Page 409)

Chapter 14: Software installation, upgrade, and update procedures 391
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 1: Application configuration and start-up (continued)
Figure 104
IP address prompt
Meridian Link using a TCP/IP connection.
If you would like a default gateway IP address configured or changed, please
enter the IP address in internet dot notation (e.g. 47.82.45.10). For no change
enter :
13 To configure or change a default gateway IP address, type the IP
address in the proper format and press [Return]. If no modification or
configuration is required, simply press [Return].
Figure 105
Subnet mask prompt
Saving default gateway IP address:
If you would like a default subnet mask configured or changed,
please enter the subnet mask (e.g. 255.255.0.0). For no change enter :
14 To configure or change a default subnet mask, type the subnet mask
address in decimal format and press [Return]. If no modification or
configuration is required, simply press [Return].
Figure 106
List verification prompt
Saving default subnet mask:
The following applications are configured:
Meridian Link
Large CCR
The following packages are configured:
1
96
97
98
99
100
101
Ethernet NSE software is enabled.
Is this correct (y/n/q)?