Meridian America Link/Customer Controlled Routing Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Link/Customer Controlled Routing Meridian America
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 595 |
| Size: | 1.95 MB |
Show table of contents
Document Outline
- Title page
- Publication history
- Contents
- About this guide
- Chapter 1: Meridian Link/CCR co-residency
- Chapter 2: Overview of Meridian Link
- Chapter 3: Overview of Customer Controlled Routing
- Chapter 4: Meridian Link/CCR hardware
- Chapter 5: Hardware installation overview
- Chapter 6: Site survey/installation checklist
- General information
- Delivery information
- Meridian 1 software checklists
- Meridian Mail hardware checklist to support Meridian Link
- IPE Module and Application Module: Meridian Link/CCR software
- Hardware
- Equipment room information
- Power and ground considerations
- Equipment cabling
- Equipment room cooling conditions
- Additional considerations
- Comments and recommendations
- Chapter 7: Unpack and inspect hardware
- Chapter 8: Hardware installation procedures
- Chapter 9: Meridian Link/CCR interface cabling
- IPE Module cabling
- Cabling the Option 11 IPE Module to external equipment
- Backplane cable rerouting for Options 21-81 CE/PE and IPE backplanes
- Cabling the Options 21-81 IPE Module to external equipment
- Application Module cabling
- Cabling the Application Module to external equipment
- Installing Ethernet LAN support
- Chapter 10: Installing peripheral devices
- VT220, VT320, and VT420 terminals
- Personal computer running Reflection 4+
- Meridian Terminal Emulator (MTE 8)
- Dot-matrix printer switch settings
- LaserJet series II printer switch settings
- LaserJet series III printer switch settings
- LaserJet series IV printer switch settings
- DeskJet and DeskJet 500 printer switch settings
- Chapter 11: Peripheral device cabling interface
- Chapter 12: Meridian 1 configuration for Meridian Link/CCR
- Conventional notation
- Configuration overview
- Configuring the VSID, HSID, and AML prompts
- Configure ESDI port (X11 Release 17)
- Enable ESDI port (X81 phase 7 or X11 Release 17)
- Configure ESDI or MSDL port (X11 Release 18 or later)
- Enable ESDI or MSDL port (X11 Release 18 or later)
- Configure SDI port for conshare (X11 Release 17)
- Configure SDI port for conshare (X11 Release 18 or later)
- Enable SDI port
- Configuring DNIS to use auto-terminating trunks
- Configuring DNIS to use Incoming Digit Conversion
- Configure devices for status change host notification
- Configure ACD DNs
- Configure Control DNs (CCR)
- Configuring a Phantom Loop
- Configuring a Phantom Superloop
- Creating a Phantom Set
- Configuring Dual VAS ID
- Traffic statistics
- Chapter 13: Meridian Mail configuration
- Chapter 14: Software installation, upgrade, and update procedures
- Chapter 15: Link configuration
- Chapter 16: Additional application configuration
- Chapter 17: Hardware upgrade
- Chapter 18: Acceptance testing
- Chapter 19: Single Terminal Access
- Chapter 20: Ordering
- List of terms
- Index
- Back