Meridian America Link/Customer Controlled Routing - Manual (Page 239)

Chapter 9: Meridian Link/CCR interface cabling 221
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
External I/O cables (Application Module)
Tables 78, 79, and 80 list external I/O cables that connect ports on the
transition cards to connectors on either the I/O subpanel or the universal I/O
panel. Table 78 lists external I/O cables that connect the I/O panel
connectors to an SDI port, the ESDI/MSDL port, the main distribution
frame (MDF), and consoles. Figure 60 shows the cables used between the
transition cards, the I/O subpanel, and external equipment. Figure 61 shows
the cables used between the transition cards, the universal I/O panel, and
external equipment. Figure 63 shows the cables used between the transition
cards, the generic I/O panel and external equipment. Figure 73 shows the
cables going to the Meridian 1 or Meridian 1 I/O panel.
Table 78
Cables from transition cards to I/O subpanel (Application Module)
Part number Length Cable description and application
NT7D46AA
(A0372653) 35 cm
(14 in.) 9-pin (DB9) round subminiature D-style cable: connects port
3 (J4) on the MVME712A or AM transition card to the J8
port
NT7D48AA
(A0372655) 35 cm
(14 in.) 25-pin (DB25) round subminiature D-style cable: connects
ports SP1 (ESDI port) and SP3 (host port) on
the MVME705B transition card to J2 and J3
NT7D60AA*
(A0373962)
(MVME712AM) 35 cm
(14 in.) 4-pin RJ11 to 9-pin subminiature D-style cable: connects the
built-in modem (teledapt connector) on the MVME712AM
transition card to J9
NT7D61DA 35 cm
(14 in.) 9-pin to 25-pin subminiature D-style cable: connects port
SP4 on the MVME712A/AM card to J1
NT7D79AA
(A0387839) 35 cm
(14 in.) 9-pin round subminiature D-style cable: connects port J1 on
the MVME712A or AM transition card to J7
NT7D95AA** 22 cm
(9 in.) 25-pin flat subminiature D-style cable: connects SP1, SP2,
and SP3 on the NT6D51AA transition card to J4, J5, and J6
* When the MVME712A card is used, the NT7D60AA cable is replaced by an NT7D46AA
cable, which connects port SP2 on the transition card to J9.
** Used only when NT6D51AA card is present (CCR Application Module).