Meridian America Link/Customer Controlled Routing User Manual
Page 419
Chapter 14: Software installation, upgrade, and update procedures 401
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 3: Load application software from tape (continued)
ATTENTION
Do not attempt to press a keyboard key until the tape active indicator
light goes from on to off and stays off. The tape drive can enter a
nonoperational state if operations are attempted before the drive is
completely ready.
2
When the tape indicator light is off, press [Return] to start the
auto-loading of the application software.
After a few moments a message appears, saying ÒInstalling Meridian
Applications. Press
3
Press [Return].
Figure 120 shows software install messages. If an error occurs,
contact your Nortel support personnel.
Figure 120
Software install messages 1
170 blocks
Preparing for installation. Please wait.
10 blocks
30 blocks
7780 blocks
1100 blocks
110 blocks
1080 blocks
2080 blocks
430 blocks
11000 blocks
11320 blocks
.
(A series of messages appear on the screen.)
.
Installation Complete.
Host based X.25 is installed.
Setting file permissions and ownerships. Please wait.
Setting file permissions and ownerships completed.
06/01/94 19:56:44 Invoking maint