KEYENCE IV Series - Manual (Page 49)

2-17 - IV Series User's Manual (Monitor) -
Cables Cables
Connecting the monitor cable/
Ethernet cable
This section describes the details on connecting the
monitor cable/Ethernet cable using the example of
connecting the monitor cable to the sensor.
1
Align the pin connection parts of the
monitor cable/Ethernet cable connector
with three pins of the cable connector,
and connect the cable to the sensor.
Align the pins and
the pin connection
* Same procedures for monitors.
2
Tighten the connector by turning the
screw-on connector in the clockwise
direction. When connecting the connector,
insert it without inclination while pushing
in and tighten it well.
(1)
Tighten the screw-on connector
(2)
When the screw stops rotating by the
locking mechanism, further tighten it
while pushing.
* Same procedures for monitors.
Repeat the steps (1) and (2) and when you cannot
tighten the screw by hand any more, use a tool
such as pliers for further tightening. Tightening
torque, retorque degree, and acceptable spaces
between connectors are shown below.
y Monitor cable/Ethernet cable
(OP-87450/OP-87451/OP-87452/OP-87453/
OP-87457/OP-87458/OP-87459)
Tightening torque : 0.8 to 1.0 N·m
Retightening degree : 5 to 10°
Spaces between connectors (reference value)
For sensors : 0 mm
For monitors : 2.2 mm
If the connector cable tightening is weak,
vibration may loosen the connector and cause
bad connections or cable disconnections.
Also, the enclosure rating may not be
maintained with loose connection.
Properly follow the procedures above and
tighten the connector completely.
Check the spaces between the monitor cable/
Ethernet cable and the cable connector.
Spaces between
connectors
z z
For sensors
Spaces between
connectors
z z
For monitors
2
Installation and Connection