KEYENCE IV Series - Manual (Page 145)

5-11 - IV Series User's Manual (Monitor) -
Names and Functions of the Operation Screen
(7) OUT information
Displays the latest status results of items which
are assigned to an output line (OUT1 to OUT4)
(Page 4-60).
y The upper limit of TrigNo is 999999. When
the number exceeds the upper limit, the
counter resets to 0 and starts counting
again.
y The upper limit of OK, NG, and TrigErrNo is
999999. The values display stops updating
when the upper limit is reached.
y The statistical information is reset under the
following conditions.
- When the [Reset] button is tapped
- When the power of the sensor is turned OFF
- When the tool is added/deleted/copied
- When the upper limit of the Color Area/
Area tool is enabled/disabled or when
the setting scale is changed by the user
operation or Tool Auto Tuning
- When the Tool Auto Tuning is started if
more than two tools other than the position
adjustment tool are being set
- When the program is switched
- When each correction of the setup
adjustment is started
- When the sensor is initialized
3
Tap the [OK] button.
The system returns to the Menu ON screen.
Hiding the statistical information
1
Tap the [View] button.
If the [View] button is not displayed, tap the
[Menu] button at the lower left corner of the
monitor.
The menus of [Tool View] and [Analysis] will be
displayed.
2
Tap the [OFF] button in the [Analysis].
The statistical information becomes hidden.
3
Tap the [OK] button.
The system returns to the Menu ON screen.
5
Operating/Adjusting