Remedy when direct connection is unavailable, Remedy when the monitor cannot, Remedy when direct connection is – KEYENCE IV Series User Manual
Page 284: Remedy when the monitor cannot be, Refer to “remedy when the, Monitor cannot be connected, A-28
A-28
- IV Series User's Manual (Monitor) -
A
Remedy when the Monitor cannot be Connected with the Sensor
Remedy when direct connection is unavailable
Status
Remedy
Retries occur repeatedly because
connection is not possible.
The status is as shown below.
y
Connection is not possible after power ON.
y
Connection is not possible using the [Connect]
button of the sensor connection setup screen.
y
Supply power to the sensor.
y
Connect the sensor and the monitor correctly and directly
with a monitor cable.
“Connecting directly” (Page 2-16)
y
After a correct connection is established as a result of a
retry, the run screen opens automatically.
y
The Sensor Connect screen opens when the [Cancel]
button or [OK] button is tapped. Tap the [Connect] button
after a correct connection has been established.
If the problem is not solved using one of the above
remedies, reset (initialize) the sensor network settings.
“Initializing the Network Settings (IP Reset Switch)”
y
The error (381) "Data transfer to sensor
fails." may also be displayed.
y
Connection became impossible after
connection was established once.
The network is connected to other network
devices such as multiple sensors or
computers.
y
Connect the sensor and the monitor correctly and directly
with a monitor cable.
“Connecting directly” (Page 2-16)
y
Tap the [OK] button and close the message.
y
In the case of a network connection, change the
configuration to network connection.
“When connecting with the sensor via a network”
Remedy when the Monitor cannot be Connected
with the Sensor