KEYENCE IV Series - Manual (Page 128)

4-60 - IV Series User's Manual (Monitor) -
Set the output items to be assigned to the output
line (OUT1 to OUT4).
“Connecting the power I/O cable of the sensor”
(Page 2-12)
“Chapter 7 Controlling with Input/Output Line”
(Page 7-1)
Main screen for the Output
Assignment
(2)
(3)
(1)
(4)
(5)
(1) [Back] button
Returns to the Tool settings screen.
“3. Tool Settings (Setting the Judgment
Method for Targets)” (Page 4-28)
(2) Output assignment button
Assigns the output item to each output line.
(3) [ON]/[OFF] button for the trigger error output
Select whether to enable/disable the output
when the trigger error occurred.
“Error Messages” (Page A-22)
(4) [Complete] button
Finishes the Settings Navigator.
“Finishing the Settings Navigator” (Page 4-5)
(5) Extended functions display button
Displays the extended functions menu for the
Output Assignment.
“Display Method of Extended Functions
Menus” (Page 4-66)
Setting range of the Output
Assignment
Setting
range
Description
OFF
Do not output.
Output function will be constantly OFF.
Total Status
When the total status result of the
tools which have been set was OK,
the output function turns ON.
The condition of the total status can
be selected from [All Tools OK] /
[Any Tool OK] / [Logic 1] to [Logic 4].
Tot.
StatusNG
When the total status result was
NG, the output function turns ON.
RUN
When the sensor is running with no
system error occurred, the output
function turns ON.
BUSY
The output function turns ON when
the system is in a state that cannot
input additional trigger; such as
during imaging, judging processing,
switching programs, and registering
external master images.
Error
The output function turns ON
when an error has occurred; such
as system error, memory readout
error for startup, external master
registration error, trigger error (when
the trigger settings are enabled).
Pos. Adj.
When position adjustment processing
is finished normally, the output function
turns ON.
Tool 01 to 16
When the status result of specified
tool is OK, the output function turns
ON. Status results can be output for
each tool.
Logic 1 to 4 When the status result of specified logic
is OK, the output function turns ON.
z „ Default value
OUT1 :Total Status (N.O.)
OUT2 :BUSY (N.O.)
OUT3 :Error (N.C.)
OUT4 :OFF
Trigger Error :OFF
y N.O./N.C. can be changed.
“Output Settings” (Page 6-27)
y The input cable assignment can be changed.
“Input Settings” (Page 6-26)
4. Output Assignment
(Setting Details of Outputting to Output Line)
1. Image Optimization 2. Master Registration 3. Tool Settings 4. Output Assignment
4
Settings Navigator (Setting the Judgment Condition)