KEYENCE IV Series - Manual (Page 160)

5-26 - IV Series User's Manual (Monitor) -
Tool Auto Tuning (Automatically Adjusting the Judgment Condition)
Tool Auto Tuning by the previous
registration information
When the information of Tool Auto Tuning
performed before turning off power of the monitor
or before disconnecting with the sensor (previous
registration information) is used, the Tool Auto
Tuning can be performed skipping the OK/NG
image registration process.
y You can additionally add a new image to the OK/
NG image registered with the previous Tool Auto
Tuning, and then perform Tool Auto Tuning.
y You can readjust the tool settings after Tool Auto
Tuning, and then repeat Tool Auto Tuning by the
registered image.
Previous registration information
OK NG OK OK
OK OK NG
Tuning based on the OK/NG images registered
in the previous Tool Auto Tuning
The previous registration information is saved in
the memory (RAM) inside the monitor, and remains
available until the power of the monitor is turned off
or the monitor is disconnected with the sensor.
When you repeatedly perform Tool Auto Tuning using
the same previous registration information, settings
might be changed each time being performed.
This phenomenon occurs since Tool Auto Tuning
consistently performs adjustment based on the latest
settings (settings changed immediately before).
1
Display the Sensor Setup Menu screen.
“Displaying the Sensor Setup Menu Screen” (Page 6-7)
2
Tap the [Tool Auto Tuning] button.
When the Tool Auto Tuning Guide screen
opens, tap the [Start] button.
3
If multiple tools are set in the program,
select the target tool for the Tool Auto
Tuning from the pull-down menu and tap
the [OK] button.
Select the tool
The Start Up Menu screen for the Tool Auto
Tuning opens.
5
Operating/Adjusting