HP Systems Insight Manager - Manual (Page 349)

Note: If the trust relationship for a system is incorrectly configured, an error message appears. See
“Replicate Agent Settings - Reference” for more information.
The Choose Source Configuration Settings page appears. The source system configurations display
without any parameters selected.
5. Select the desired settings as needed. You can select each parameter individually. At least one must be
selected to continue. You can also select to Wake target systems from low power mode before
configuring
. See “Replicate Agent Settings - Reference” for more information.
6. Select one of the following options to execute the task:
•
Click Schedule to schedule when the task should run. See “Scheduling a task” for more information.
•
Click Run Now to run the task immediately. The Task Results page appears. See “Task results
list” for more information.
•
Click Previous to return to the previous page.
Note: The Replicate Agent Settings task uses the Secure Task Execution (STE) feature. See “About
secure task execution” for more information.
Related procedure
▲ Scheduling a task
Related topics
•
Replicating trusted certificates
•
Replicate Agent Settings - Reference
•
About secure task execution
Replicate Agent Settings - Reference
Determining a trust relationship
When selecting the source system from the list, a trusted column displays that indicates whether a trust
relationship exists between the management server and the indicated system. If a trust relationship is not
configured for that system, that system is marked no in the trusted column.
Changing a trust relationship
To change a trust relationship for a system, click configure in the appropriate row. The HTTP server
configuration page or System Management Homepage for the associated system appears.
Wake on LAN feature
Wake on LAN (WOL) is a feature that is used by HP Systems Insight Manager (HP SIM) to bring a target
system that is in Advanced Configuration Power Interface (ACPI) Standby mode or powered off to full power.
The Replicate Agent Settings feature can optionally use the WOL feature to wake target systems that are in
low power mode so that they can be configured. A system can be remotely powered up if it is equipped
with a WOL-enabled NIC, or it has ACPI support in the operating system. See the target ProLiant server
documentation to determine if Remote WakeUp is supported by the server.
Replicate Agent Settings events
Replicate Agent Settings events are used to show the status of a Replicate Agent Settings task. They reflect
successful or unsuccessful attempts of a Replicate Agent Settings task execution. They are logged in the job
details for the corresponding Replicate Agent Settings task.
Replicate Agent Settings 349