HP AUTOMATIC XT SPAY GUNS 311051D User Manual
Automatic xt spray guns, Instructions - parts
311051D
Instructions - Parts
Automatic XT Spray Guns
Airspray, HVLP, and Compliant guns for spraying paints and coatings.
See page 3 for model information.
100 psi (0.7 MPa, 7 bar) Maximum Working Fluid Pressure
100 psi (0.7 MPa, 7 bar) Maximum Working Air Pressure
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
TI8085a
Part No. 249369 Airspray Gun shown mounted on
Part No. 288221 Manifold.
Part No. 249377 Airspray Gun with fluid control
shown mounted on Part No. 288223 Manifold.
TI8169a
II 2 G c T6
Table of contents
Document Outline
- Related Manuals
- Models
- Warnings
- Selection Charts
- Proper Needle/Nozzle Selection
- Gun Selection
- Air Caps
- Air Flow
- Installation
- Ventilate Spray Booth
- Configure Gun and Manifold
- Install Air Fittings
- Ground System
- Mount Gun
- Setup
- Connect Air Line
- Connect Fluid Hose
- Flush Spray Gun
- Position Air Cap
- Adjust Spray Pattern
- Operation
- Pressure Relief Procedure
- Apply Fluid
- Daily Gun Care
- General System Maintenance
- Clean and Flush Gun
- Troubleshooting
- General Troubleshooting
- Spray Pattern Troubleshooting
- Service
- Replace Fluid Packings and Air Seals
- Reassembly
- Parts
- Accessories
- Dimensions
- Mounting Hole Layout
- Mounting Hole Layout
- Technical Data
- Graco Standard Warranty
- Graco Information