Nortel Networks 1000M - Manual (Page 95)

Summary of installation procedures 95
20. Connect the system to an AC power source. Make sure that the source
matches the label on the back of the chassis. Turn the power switch
to "ON".
21. Start and test system. See Software Installation Program on page 320 .
Refer to the following procedures:
• Procedure 48 "Startup procedure for a new system installation, using
the Small System Controller card" (page 259)
• Procedure 49 "Startup procedure for a previously installed system"
(page 261)
22. Install the system software. See "Installing software in a new system"
(page 278) . Refer to "E and M TIE trunk card (2280 Hz)" (page 357) .
23. Connect the M2616 or the M2008 administration and maintenance
telephone with display. See "Connecting the telephones" (page 323) .
24. Install the telephones, if you have not already done so, and activate
them. See "Connecting the telephones" (page 323) .
25. Connect the trunks to the system. See "Terminal setup" (page 249) .
26. Perform a system backup using LD 43.
27. Install any remaining equipment. See "Connecting an external alarm"
(page 369) .
28. Replace the faceplate.
a. Fit the brackets at the bottom of the faceplate into the raised edge at
the bottom of the chassis. Move slightly to the left. See Figure 33
"Aligning the faceplate with the chassis" (page 96) .
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.