Nortel Networks 1000M User Manual

Page 91

Installing the Chassis system

Contents

This section contains information on the following topics:

"Summary of installation procedures" (page 91)

Summary of installation procedures

WARNING

Before a Small System can be installed, a network assessment
must be performed and the network must be VoIP-ready.

If the minimum VoIP network requirements are not met, the system
will not operate properly.

For information on the minimum VoIP network requirements and
converging a data network with VoIP, refer to Converging the Data
Network with VoIP Fundamentals (NN43001-260).

The following list provides a high-level summary of installation procedures
for the CS 1000M Chassis or Meridian 1 PBX 11C Chassis. Where
applicable, the summary contains references to chapters that describe the
procedures in more detail.

Note: For a CS 1000M Chassis system, install the Signaling
Server. Refer to Signaling Server Installation and Commissioning
(NN43001-312) for instructions.

1. Read the safety instructions in

"Important safety instructions" (page 59)

2. Make sure that you have read and completed the instructions contained

in the planning chapters of Communication Server 1000M and Meridian
1 Small System Planning and Engineering (NN43011-220).

3. Make sure that system and site requirements have been met. See

Communication Server 1000M and Meridian 1 Small System Planning
and Engineering (NN43011-220).

Nortel Communication Server 1000

Communication Server 1000M and Meridian 1 Small System Installation and Commissioning

NN43011-310

01.04

Standard

Release 5.0

13 May 2008