Nortel Networks 1000M - Manual (Page 269)

Configuring IP Line data 269
Figure 127
OTM 2.2 primary and secondary IP addresses
Transmitting IP Line node configuration data
IP Line node and card properties are configured in the OTM IP Line IP
Phones application and then transmitted to the VGMCs. OTM converts the
configuration data to text files and transmits files to the line cards. Refer
to IP Line Fundamentals (NN43001-500) and Telephones and Consoles
Fundamentals (NN43001-567). Complete the following steps:
1. Set the Leader 0 IP address from TTY connected to local RS232
maintenance port.
2. Transmit the node and card properties from OTM IP Line IP Phones
application to Leader 0.
3. Transmit card properties to all cards in the node.
Configuring IP Line data with Element Manager
Refer to IP Line Fundamentals (NN43001-500) and IP Phone Fundamentals
(NN43001-368) for a detailed description of the procedures listed below.
1. Manually add an IP Telephony node. Do not use this node anywhere
else. It is unique for this cabinet or chassis.
2. Configure SNMP traps and community name access for security.
3. Configure Voice Gateway Profile data.
4. Configure Quality of Service.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.