Nortel Networks 1000M - Manual (Page 92)

92 Installing the Chassis system
4. Make sure that you have created the equipment layout plan and card
slot assignment plan. See Communication Server 1000M and Meridian
1 Small System Planning and Engineering (NN43011-220).
5. If your Small System requires earthquake bracing, refer to "Bracing
against earthquakes" (page 63) .
For your system to be braced against earthquakes, you must install the
chassis on a wall in a vertical position.
6. Locate the box containing the Small System equipment.
7. Install the chassis. See "Mounting the chassis" (page 107) . Refer to one
of the following procedures, depending on the position in which you will
install the chassis:
• Procedure 8 "Installing the chassis in a 480 mm (19 in.)
rack/equipment cabinet" (page 110)
• Procedure 9 "Installing the chassis on a wall in a vertical position"
(page 114)
• Procedure 10 "Installing the chassis on a wall in a horizontal
position" (page 119)
8. Install the chassis expander. See "Connecting the chassis expander
to the chassis" (page 123) . You can skip this step if your system only
has one chassis.
Install the chassis expander the same way as the chassis. Refer to
Procedure 11 "Adding a chassis expander" (page 123) . This procedure
describes how to connect the chassis to the chassis expander by using
the two NTDK95 CE-MUX/DS-30X cables.
Note: To ensure correct usage, one end of the NTDK95 cable is
designated to connect to the expansion cabinet.
Figure 31
Expansion Cabinet end of NTDK95 cable
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.