Nortel Networks 1000M User Manual
Page 77
Installing a new Cabinet system
77
to
"Installing fiber expansion" (page 163)
. For a system with IP
expansion, refer to
"Installing IP expansion" (page 179)
g. Install the remaining circuit cards. Refer to
.
h. Install the cross-connect terminal and cables. Refer to
and connecting cross-connect terminals" (page 213)
i.
Install the power fail transfer units (PFTUs) if provided. Refer to
"Installing Power Failure Transfer Units" (page 229)
.
j.
Connect the SDI and Ethernet network interfaces. Refer to
"Installing and connecting SDI and Ethernet network interfaces"
(page 237)
.
2
Install expansion cabinets.
a. Mount the cabinets as described in
.
b. Remove the drip tray from each cabinet to expose the cable
routing grooves at the bottom rear of the cabinet.
c. Install the cabinet ground wire for the cabinets as described in
"Installing the system ground" (page 127)
.
d. Install the power supply as described in
supplies for the Cabinet system" (page 137)
.
e. Install the reserve power supply if required. Refer to
and connecting reserve power supplies for the Cabinet system"
(page 147)
.
f.
Install the expansion cabinet SSC or Fiber Receiver card,
daughterboards, and cables. Refer to
and
"Installing IP expansion" (page 179)
g. Install the remaining circuit cards. Refer to
.
h. Install the cross-connect terminal and cables. Refer to
and connecting cross-connect terminals" (page 213)
i.
Install the power fail transfer units (PFTUs) if provided. Refer to
"Installing Power Failure Transfer Units" (page 229)
.
j.
Connect the SDI and Ethernet network interfaces. Refer to
"Installing and connecting SDI and Ethernet network interfaces"
(page 237)
.
3
For fiber connectivity, go to
.
For IP connectivity, do one of the following:
•
For point-to-point 100BaseF connectivity, go to
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.