Nortel Networks 1000M - Manual (Page 113)

Wall mounting in a vertical position 113
Wall mounting in a vertical position
Items required
To install the chassis on a wall in a vertical position, you require the following
items:
• equipment layout plan
• chassis bracket
• wall bracket
• five 25 mm (1 in.) #12 wood screws provided in the bracket kit (or other
appropriate fasteners) to hold the wall brackets and chassis on the wall
• four #8-32 machine screws, used to attach the chassis brackets to the
wall
• one 20 mm (3/4 in.) piece of plywood fastened to the wall
The NTTK08 bracket kit contains all of the above items, with the exception
of the equipment layout plan and the plywood.
DANGER
A chassis is 13.5 kg (30 lb) with circuit cards installed. Make
sure that you fasten the equipment securely to the wall. Use
fasteners designed to hold securely to the type of surface that will
support the equipment. When using 20 mm (3/4 in.) plywood, or
other similar material as a backboard, make sure to attach the
backboard directly to the wall studs in a minimum of six locations.
Refer to Figure 46 "Typical layout for installing the chassis on a wall in a
vertical position" (page 114) for guidelines on how to position the system
components.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.