Nortel Networks 1000M - Manual (Page 20)

20 Cabinet system equipment
Introduction
This chapter identifies major components of Cabinet systems. Identification
codes are given where appropriate.
For a description of the Signaling Server for a CS 1000M Cabinet, refer to
Signaling Server Installation and Commissioning (NN43001-312).
Cabinets
The NTAK11 cabinet is used for both main and expansion cabinets.
Figure 1
NTAK11 cabinet
Cable connectors
Connectors for cables to the cross-connect terminal and SDI ports are found
at the bottom of each cabinet.
The AUX, SDI, and Ethernet connectors are located at the bottom left-hand
side of the cabinet. The AUX port connects the cabinet to auxiliary
equipment such as a Power Failure Transfer Unit (PFTU). The SDI connector
in the main and IP expansion cabinets interfaces three SDI ports using a
three-port SDI cable. The Ethernet connector in the main cabinet provides
a 10 Mbit/s Ethernet port.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.