Nortel Networks 1000M - Manual (Page 260)

260 Starting the Chassis system
2 Connect the power cord from the power connector on the back of the
chassis to an AC power source. See
Figure 126 "Power connector
on the back of the chassis" (page 260) . Secure the power cable
with a cable tie.
Figure 126
Power connector on the back of the chassis
3 Turn the power switch to ON.
4 Observe the TTY or terminal screen. The TTY must be connected
to TTY port 0.
5 When you have completed the software installation (see "Installing
software in a new system" (page 278) ), observe the screen again.
6 Perform an EDD using LD 43.
—End—
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.