Nortel Networks 1000M - Manual (Page 291)

Installing software in a new system 291
2 Select option 1 to install software on the IP Expansion Cabinet or
Chassis.
Software Installation Main Menu:
1. Media Gateway/IPExpansion Cabinet
2. Call Server/Main Cabinet
[q]uit, [h]elp or [?], - redisplay
Enter selection: 1
3 In the Media Gateway/Expansion Cabinet Software Installation
Main Menu, select option 2 to access the Utilities menu.
Media Gateway/Expansion Cabinet Software Installation
Main Menu:
1. Media Gateway/Expansion Cabinet Installation - From
Software Delivery Card
2. Utilities
[q]uit, [p]revious, [m]ain menu, [h]elp or [?],
- redisplay
Enter selection: 2
4 In the Utilities menu, select option 1 to perform IP configuration.
Utilities Menu:
1. IP Configuration (L3)
2. Review Upgrade Information
3. Clear Upgrade Information
4. Flash Boot ROM Utilities
5. Current Installation Summary
6. IP FPGA Utilities
[q]uit, [p]revious, [m]ain menu, [h]elp or [?],
- redisplay
Enter selection: 1
Do you wish to do IP configuration? (y/n/[a]bort): y
5 The IP Configuration menu displays.
Select Manual Configuration (option 2).
ATTENTION
IIMPORTANT
BOOTP is a broadcast message used for IP Address discovery.
• For Point-to-Point installation, you must select option 1.
• For Layer 2 LAN installation, the recommended selection is
option 1.
• For Layer 3 LAN installation, you must select option 2.
IP Configuration Menu:
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.