Nortel Networks 1000M User Manual
Page 226
226
Installing and connecting cross-connect terminals
Figure 107
Cable connectors on the back of the chassis
3
Tighten the Velcro straps when you have connected each cable to
the chassis.
4
Terminate all the 25-pair cables installed at the cross-connect
terminal.
Label all the cables at the cross-connect terminal blocks according
to the card slot assignment plan.
5
Install the AUX cable in the lower 9-pin connector located on the
bottom left-hand side of the chassis. See
.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.