Nortel Networks 1000M User Manual
Page 160
160
Installing Small System Controller cards on stand-alone systems
Installing the NTDK20 SSC card on the cabinet or chassis
The following components must be installed on the SSC card before it is
inserted into the cabinet or chassis:
•
software daughterboard
•
security device
Follow
Procedure 19 "Installing the software daughterboard and security
to install these components on the SSC card.
WARNING
The NTDK20 SSC card is equipped with components on both
sides of the circuit board. Be careful not to damage any of the
components when handling the card.
Procedure 19
Installing the software daughterboard and security device
Step
Action
1
Put on the antistatic wrist strap.
2
Place the SSC card on a clean, flat, electrostatic discharge
(ESD)-dissipated surface.
3
Install the software daughterboard on the connector as shown in
Figure 73 "Location of software daughterboard and security device
on the NTDK20 SSC card" (page 161)
4
Press firmly on the standoffs to ensure that the daughterboard is
secured well to the SSC card.
5
Insert the security device labeled NT_STD in the socket with the
device markings facing outwards, as shown in
software daughterboard and security device on the NTDK20 SSC
card" (page 161)
.
6
Insert the SSC card into slot 0 of the cabinet or chassis. Lock the
card into the faceplate latches.
—End—
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.