Nortel Networks 1000M - Manual (Page 432)

432 Changing preprogrammed data
Procedure 79
Changing a route access code
Step Action
1 Pick up the handset of the administration telephone.
2 Enter the administration Flexible Feature Code to access the
administration menu. (For some countries, this value is listed in
Table 90 "Flexible Feature Codes" (page 385) .)
3 Enter the default administration telephone password. (For some
countries, this value is listed in
Table 74 "Passwords and codes"
(page 374) .)
You hear special dial tone and the prompt
"TASK?"
appears on the top line of the character display. If you press the
asterisk, "2 CHANGE ROUTE ACCESS" appears on the second line
of the character display.
4 Select "2 CHANGE ROUTE ACCESS" by entering the number "2".
The prompt
"ROUTE ACCESS?"
appears on the character display.
5 Enter the access code of the route you want to modify, and press
the pound key (#).
The prompt
"NEW ACCESS CODE?"
asks you for a new access code for the route.
6 Enter the new access code and press the pound key.
The display shows
"CODE CHANGED".
After a delay of approximately 4 seconds you hear special dial tone
and the sequence is repeated when the prompt
"ROUTE ACCESS?"
appears.
OR
If the route access code is not available for use, you hear overflow
tone. The display shows
"USED, ROUTE ACCESS?"
and you must repeat this step.
You must enter a different access code. This sequence continues
until you enter an appropriate new access code.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.