Nortel Networks 1000M User Manual

Page 339

Activating telephones

339

If the extension number is not available for use, the character display
shows "ERROR, EXTENSION?" and you hear overflow tone.

This happens when you choose an extension number manually or
when extension numbers are entered for additional keys. A default
extension number will not be offered if it is not available.

You must repeat

step 3

and manually enter a new extension number.

Note 1: If other keys require secondary extension numbers,
you are prompted until you enter all of the required extension
numbers for the model.

Note 2: These extension numbers cannot be defaulted. The
text display prompting for further extension numbers is "KEY
kk EXT?" where "kk" represents the key number requiring the
extension number.

Note 3: Each prompt for another extension number is
accompanied by special dial tone. When you are programming
an extension number, the lamp associated with that number on
the telephone is lit.

Hang up the telephone receiver.

After approximately 10 seconds, the telephone is configured.

Note: If you replace the handset before completing the prompt
sequence, the installation will automatically fail. This can be
useful if you make an error and want to restart the procedure.

—End—

Activating a default model without a character display

Procedure 67

Activating a default model telephone without a character display

Step

Action

Plug the telephone set into the jack and wait 20 seconds before
picking up the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook again.
Repeat this procedure until dial tone is received.

Note: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using
the Modular Telephone Relocation feature.

Nortel Communication Server 1000

Communication Server 1000M and Meridian 1 Small System Installation and Commissioning

NN43011-310

01.04

Standard

Release 5.0

13 May 2008