Nortel Networks 1000M - Manual (Page 445)

Configuring your CAP 445
To configure RAN trunk routes, respond as follows for prompts in LD 16:
LD 16: Defining and modifying trunk routes
Prompt Response Description
REQ aaa "aaa" = NEW, OUT, CHG, END
TYPE bbb "bbb" = trunk type (COT, TIE, DID, etc.)
DMODL ccc "ccc" = the default model number for this route.
To configure RAN trunks, respond as follows for prompts in LD 14:
Note: LD 14 is also used to assign incoming trunks with a Priority (via
CLS=APY)
LD 14: Defining and modifying trunks
Prompt Response Description
REQ aaa "aaa" = NEW, OUT, CHG, MOV, END
TYPE bbb "bbb" = the trunk type (COT, TIE, DID, etc.)
"M" is optional. Enter "M" if you are using a model trunk.
MODL Model Number
Note: Only prompted if "M" is entered in response to the "TYPE"
prompt.
1-127 Range for CS 1000M Small System, Meridian 1 Small System,
CS 1000S system, Media Gateway 1000B, and Media Gateway
1000T.
TN Terminal number
Note: Not prompted if "M" is entered in response to the "TYPE"
prompt.
c u Format for CS 1000M Small System, Meridian 1 Small System,
CS 1000S system, Media Gateway 1000B, and Media Gateway
1000T, where c = card and u = unit.
CDEN Note: Not prompted if "M" is entered in response to the "TYPE"
prompt.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.