Nortel Networks 1000M - Manual (Page 366)

366 Connecting the trunks
Activating a default model trunk
Due to the automatic 30 second timeout on the administration menu,
prepare the data that you want to input before you begin. To determine
the corresponding TNs and trunks, check the location of trunk cards in
the cabinet or chassis or use LD 32.
Procedure 72
Activating a default model trunk
Step Action
1 Pick up the handset of the administration telephone.
2 Enter the administration Flexible Feature Code to access the
administration menu.
The prompt "PASSWORD?" appears.
3 Enter the default administration telephone password.
You hear special dial tone, and the prompt
"TASK?"
appears in the top line of the character display.
The second line of the display reads "1 ADD TRUNK".
4 Select "1 ADD TRUNK" by entering the number "1".
The prompt "ROUTE ACCESS?" appears on the character display.
5 Enter the access code of the route to which you want to add a trunk
and press the pound key (#).
The prompt
"TN?"
asks you to enter a TN (Terminal Number) from one of the installed
trunk cards.
If you do not enter a valid route number, "TN?" does not appear and
the screen remains the same. If the type of trunk card does not
match the route, the prompt "ROUTE ACCESS?" appears again,
and you hear overflow tone.
6 Enter the TN in Small System format (cu) and press the pound key.
The prompt
"MODEL"
appears. If you enter an invalid TN, the display shows "INVALID,
TN?" and you must enter a new TN using the Small System format.
7 Press the digits to select a trunk model (as assigned in LD 16).
The character display shows
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.