Nortel Networks 1000M User Manual
Page 263
263
Voice Gateway Media Card
configuration
Contents
This section contains information on the following topics:
"Voice Gateway Media Card configuration on the Small System" (page 264)
"Configuring Voice Gateway Media Cards on cabinets or chassis" (page 265)
"Configuring IP Line data" (page 268)
"Configuring IP Line data with OTM 2.2" (page 268)
"Transmitting IP Line node configuration data" (page 269)
"Configuring IP Line data with Element Manager" (page 269)
"Transferring node configuration from Element Manager to the Voice Gateway
Media Cards" (page 270)
"Upgrading software and firmware" (page 271)
Introduction
The Voice Gateway Media Card (VGMC) supports the Nortel IP Phone set.
The VGMC provides a communication gateway between the IP data network
and the Small System. The IP Phone translates voice into data packets for
transport using Internet Protocol (IP). The IP Phone uses the customer’s
IP network (TLAN network interface) to communicate with the VGMC and
the optional Dynamic Host Configuration Protocol (DHCP) server. A DHCP
server is used to provide the required information needed to enable the IP
Phone network connection and to connect it to the VGMC.
There are three types of VGMC:
•
ITG-P 24-port line card (occupies 2 slots)
•
Media Card 8-port line card (occupies 1 slot)
•
Media Card 32-port line card (occupies 1 slot)
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.