Nortel Networks 1000M - Manual (Page 93)

Summary of installation procedures 93
9. Install the chassis ground wire for the chassis and chassis expander at
this site. See "Installing the system ground" (page 127) .
Refer to one of the following procedures:
• Procedure 12 "Grounding the cabinets or chassis" (page 129)
• Procedure 13 "Earthing the cabinets or chassis (UK)" (page 134)
To ground multiple pieces of equipment in a rack/cabinet when one or
more pieces of equipment does not have a grounding lug, see
"Multiple
pieces of equipment in an equipment rack/cabinet" (page 134) .
10. If you require a UPS, install the UPS according to the manufacturer’s
instructions.
11. If you have not already done so, remove the faceplate of the chassis.
a. Loosen the quick-release screws on the faceplate of the chassis.
See Figure 32 "Faceplate on the Chassis system" (page 93) .
b. Lift the faceplate up.
c. Remove the faceplate.
Figure 32
Faceplate on the Chassis system
12. Install the Small System Controller (SSC) card and the 48-port Digital
Line Card.
a. Install the SSC card in CPU slot 0 of the chassis. For a system
without fiber or IP expansion, refer to "Installing Small System
Controller cards on stand-alone systems" (page 159) . For a system
with fiber expansion, refer to "Installing fiber expansion" (page 163) .
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.