Nortel Networks 1000M - Manual (Page 48)

48 Chassis system equipment
• The NTTK02 dual-port 100BaseF
Lineside E1/T1 cards
The Chassis system also supports the following lineside cards:
• NT5D14 lineside T1
• NT5D34 lineside E1
For further information about T1/E1 lineside cards, refer to Circuit Card
Reference (NN43001-311).
Fiber expansion
For non-IP expansion, fiber expansion daughterboards in the chassis and
Fiber Receiver cards in the expansion chassis allow for fiber connectivity
between the chassis and up to four fiber expansion chassis or cabinets.
Fiber Receiver card
Multi-chassis Small Systems require an NTDK23 Fiber Receiver card in
each additional chassis. The NTDK23 supports a 10 m (33 ft) plastic
fiber-optic cable. Each Fiber Receiver card provides one SDI port for
remote TTY access.
Fiber Expansion daughterboard
Fiber expansion daughterboards must be installed on the NTDK20 SSC
card in order to connect to additional chassis. There are two kinds of fiber
expansion daughterboards that can be matched with the NTDK23 Fiber
Receiver card:
• NTDK22 Single-port Fiber Expansion daughterboard
• NTDK84 Dual-port Fiber Expansion daughterboard
Both daughterboards are used with the A0632902 Fiber-optic (multimode)
cable.
Routing Guides
Each chassis in a multi-chassis system requires a Routing Guide, in order
to route and manage the fiber-optic cable. Only one guide is required
in each chassis.
Telephones and attendant consoles
The Chassis system supports the following telephones and attendant
consoles:
• Analog (500/2500-type) telephones, with or without message waiting
lamps
• Meridian Digital Telephones (M2006, M2008, M2216, M2616)
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.