consoles supported by the Cabinet system and Chassis system. Refer to
the instructions provided with the telephone or console and to Telephones
and Consoles Fundamentals (NN43001-567) for detailed information about
installing telephones and consoles.

Refer to

"Preprogrammed data" (page 373)

for information about

preprogrammed data.

Before you continue, install the cable from the slot that contains the line card
associated with the telephone being connected. Refer to

"Installing and

connecting cross-connect terminals" (page 213)

, if you require additional

cable installation.

Cable assignments for the Cabinet system

The cables from each cabinet are labeled J1 through J10 at the
cross-connect terminal. Each cable represents a specific set of Terminal
Numbers (TNs) as shown in

Table 45 "Terminal number assignments: Main

and Expansion Cabinets 1 and 2" (page 332)

DANGER

DANGER OF ELECTRIC SHOK

Always use caution when installing or modifying telephone lines.
Avoid installing telephone wiring during a lightning storm. Do
not install telephone jacks in wet locations unless the jack is
specifically designed for wet locations. Never touch uninsulated
telephone wiring unless the line has been disconnected at the
network interface.

Nortel Communication Server 1000

Communication Server 1000M and Meridian 1 Small System Installation and Commissioning

NN43011-310

01.04

Standard

Release 5.0

13 May 2008