Nortel Networks 1000M - Manual (Page 253)

Installing and connecting an Ethernet cable 253
Cabinet system: IP expansion 10BaseT port
The Cabinet system provides one 10 Mbit/s Ethernet connection to a Local
Area Network (LAN). The Ethernet cable connector is located just left of the
retaining bar in the main and IP expansion cabinets, as shown in
Figure 121
"Ethernet port location on the cabinet" (page 253) . The 10BaseT Ethernet
port available on the SSC of an IP expansion cabinet is functional. However,
the Ethernet port on the IP expansion cabinet does not have a default IP
configuration. This means that the IP port configuration must be performed
before it can be used.
It is not recommended to use the remote 10BaseT port in normal mode, as
maintenance or alarm management are not available. In survival mode it
assumes the system level configuration of the main cabinet port.
Figure 121
Ethernet port location on the cabinet
J7 Jumper plug
The J7 jumper plug must be in place on the SSC card for the Ethernet
function to operate. The jumper plug is present when the SSC card is
shipped. See
Figure 122 "J7 Jumper Plug location on NTDK20 SSC card"
(page 254) .
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.