Changing – Nortel Networks 1000M User Manual
Page 419
![background image](/manuals/191775/419/background.png)
Changing the default numbering plan
419
•
If the first digit is being used by Meridian Mail, trunk routes, or other
data, you must remove these interferences. Follow the instructions
found in
"Removing numbering plan conflicts" (page 422)
.
Changing the first number in the numbering plan
To change the first number in the numbering plan perform the following
procedure.
Procedure 76
Changing the first number in the numbering plan
Step
Action
1
Pick up the handset of the administration telephone.
2
Enter the administration Flexible Feature Code. (For some countries,
this value is listed in the
Table 90 "Flexible Feature Codes" (page
3
Enter the administration telephone password. (For some countries,
this value is listed in
Table 74 "Passwords and codes" (page 374)
4
You hear special dial tone and the prompt "TASK?" appears on the
top line of the character display.
5
Press the asterisk (*) three times.
The second line of the character display reads "4 INSTALLATION
OPTIONS".
6
Select "4 INSTALLATION OPTIONS" by entering the number "4".
The character display reads:
1 DEFAULT SETS
2 NUMBERING PLAN
7
Select "2 NUMBERING PLAN" by entering the number "2".
The character display reads:
FIRST NUMBER (XXXX)?
8
To create a new first number, enter the digits you want and press
the pound key.
9
The number you enter as the first number in the numbering plan is
assigned to slot 1, unit 0 of the Main Cabinet or Chassis. The default
numbers assigned to the remaining card and unit combinations are
in sequence, assuming each slot has up to 16 units.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.