Nortel Networks 1000M User Manual
Page 274
274
Installing software
Software Installation Program
The Software Installation Program provides a menu-driven method of
selecting from the different options of installing, modifying, or upgrading
the following:
•
software
•
customer data
•
service level
•
License parameters
The flash ROM stores information about the selections. The information is a
list of instructions that the program follows when it runs.
Starting the program
The Software Installation Program must run from TTY 0 (port 0 on card 0).
There are two methods to start the Software Installation Program:
•
Issue the
UPGRADE
command in LD 143.
•
Press the
installation prompt during SYSLOAD.
Note: When you turn on a new system before you have installed
the software, the Software Installation Program is called up
automatically.
Function selection
The Software Installation Program is menu driven. The main menu provides
the core functionality of the program. The Software Installation Program
includes the following key functions:
•
installs software in a new system
•
upgrades and modifies software in an existing system
•
uses utilities to work with archived databases, review data, back up data,
undo an installation in progress, and clear unwanted data
After you have made all installation or upgrade selections, you must enter
valid keycodes. The system validates the keycode. If you enter an invalid
keycode, the installation function does not continue.
Note: If you enter a keycode that is not valid, the software and
databases on the present system are not affected.
When the keycode validation passes, the software is installed on the system.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.