Nortel Networks 1000M - Manual (Page 429)

Creating model trunks and changing route access codes 429
Digital telephones
Note: To print M3000 telephone models, you must enter "TYPE 3000
M". If you enter "TYPE 2XXX M", you print all the Meridian Digital
Telephone models except the M3000.
LD 20
REQ PRT
TYPE 2XXX M or
3000 M
where "XXX" = the telephone type
MODL YYY where "YYY" = the telephone model number
(between 1–127).
If you want to print all of the models for this
telephone type, leave this value blank.
Removing model telephones
Use LD 10 to remove analog telephone models and LD 11 to remove digital
telephone models. Respond as follows to the prompts in either overlay:
LD 10 or LD 11
REQ OUT
TYPE XXXX M where "XXXX" = telephone type for the model
you are removing. (Example: 500, 2006, 2317,
2216, 3000, etc.)
CUST 0
MODL YYY where "YYY" = the model number associated
with the telephone type you are removing.
(Valid range is 1–127.)
Creating model trunks and changing route access codes
If you need a trunk that is different from the default models provided in
Small System software, use LD 14 to design your own model. Change route
access codes using the administration telephone.
If you require additional assistance when creating your own model
telephones and trunks, refer to the system software NTPs that are shipped
with every system.
Creating model trunks
To create a new model trunk, load LD 14 and enter the following commands
on the TTY:
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.